http://www.jtii.com

Introduction Visibility Cab Comfort Controls The Rotor Cross FlowTM Fan Engine More Features: Designed Around You Overbuilt Features Safety Service Specifications: 2144 2166 2188

OVERBUILT TO OVERACHIEVE In the frenzy of harvest, there is simply no room for downtime. That’s why the 2100 Series Axial Flow® combines are built stronger in ways that you may never even notice. Decades of experience and exhaustive focus group studies have pointed out key areas for modification and strengthening. Some of those areas are indicated here, but there are many more improvements that you may never be aware of. And that’s what we intended. Feeder Reverser: The tightener has been removed to prevent chain throw and reduce sharp chain bends around small-diameter sprockets, which will prolong the life of the feeder. The shaft-speed sensor has been relocated to prevent sensor damage. PFC System The Pressure Flow Compensated (PFC) hydraulic system operates the steering, reel, unloader, swing, Field Tracker* option and header raise. *Field Tracker is a registered trademark of HCC, Inc. Straw and Chaff Spreader Mixes the chaff in with the straw, spreading total residue through the full width of cut. And it’s all done without the use of additional hydraulics. Sieve Choices Sieve choices allow you to quickly install the right sieve to match your crop and conditions for better cleaning action. Tailings Return Auger Tailings return auger shaft has improved durability by increasing the diameter to 1.25" (32 mm). Telephone/Radio Jack Comes standard and is conveniently located right of the driver’s seat by the cup holder. Automatic Feeder Cutoff If the speed of the feeder pivot shaft drops dramatically, the automatic feeder cutoff stops the cutting, gathering and feeding units, which protects against damage and downtime. Standard in the 2100 Series, this safety feature is not available on the primary competitor. Feeder Chains Feeder chain slats bolt onto the feeder chain for added durability and easier slat replacement. Rock Trap Rock trap option enables you to cut closer to the ground in rocky fields. Install it between the feeder and rotor, and its powerful beater will knock away rocks and other unwanted material. You just empty the trapped rocks at your convenience. Clean-Grain Cross Auger Clean-grain cross auger on the 2188 has larger bearings and an increased shaft thickness of 1.375" (35 mm) for improved reliability. Final Drives Final drives that include heavier housings and larger output shafts are standard on all 2188 models and on 2144 and 2166 models with duals.